Repair questions · Watches
What do watch water-resistance ratings (3 ATM, 5 ATM, 10 bar, 100 m) mean, and can I swim or shower with mine?
From JewelryRepair.com: over 50,000 repairs since 1989 · 4.9 from 187 Google reviews (as of )
The short version
- One bar or one ATM is roughly the pressure of 10 meters of water, so 5 ATM, 5 bar and 50 m are the same rating.
- Rough guide: 3 ATM for rain and hand-washing, 5 ATM for light swimming, 10 bar for snorkeling and water sports. For scuba, wear a true diver's watch.
- Hot water, steam and soap age gaskets faster, and water resistance isn't permanent.
Prices
| Service | Price | What's included |
|---|---|---|
| Water-Resistance Pressure Test | from $175 | Pressure-chamber test against the watch's stated rating, with crown, case back and crystal seals checked and a documented result; resealing quoted for approval if it fails. |
| Watch Battery & Pressure Check | from $30 | New battery, case gasket inspected, cleaned and re-seated, and a pressure check; a new case back gasket is $25 more. |
| Stem & Crown Replacement | from $75 | New stem and/or crown, fitted with a fresh gasket where the design calls for one. |
| Watch Overhaul | $195 quartz $295 mechanical | Full movement service: disassembly, cleaning, lubrication, regulation and reseal. |
What 3 ATM, 5 ATM, 10 bar and 100 m actually mean
One bar is about the pressure of 10 meters of seawater, and one atmosphere is 1.01325 bar, so watches use ATM and bar interchangeably. A case back marked 5 ATM, 5 BAR or 50 m makes the same claim three ways.
The claim is about a test, not a dive. The number records a leak test done on new watches from the production run, under still water pressure; it isn't a promise that the watch can live at that depth, and the watch on your wrist may never have been tested itself. Real water adds movement, temperature swings, soap, salt and aging gaskets, which is why a 30 m watch isn't a swimming watch.
Two ISO standards sit behind the labels. ISO 22810:2010 covers ordinary water-resistant watches up to their stated depth. ISO 6425 covers diver's watches: rated to at least 100 m, tested at 125% of the rated pressure, with extra checks such as a time-preset bezel, legibility in the dark and salt-water resistance, and marked DIVER'S WATCH with the depth. The older ISO 2281 standard barred the word "waterproof" for watches.
A case back that says only "water resistant" with no number makes the smallest claim; Timex describes such watches as fine for splashes and rain but not for submersion. "Stainless steel back" simply names the case material. For the definition and the standards in brief, see our water resistance glossary entry.
Can I swim or shower with it? Rating by rating
Makers publish their own charts, and they differ a little. Here are Seiko's and Timex's side by side, with feet rounded:
- 3 ATM / 3 bar / 30 m (about 100 ft): Seiko lists splashes and rain; Timex lists hand-washing. Neither lists swimming, and 3 ATM is the lowest rating on either maker's chart.
- 5 ATM / 5 bar / 50 m (about 165 ft): Seiko adds swimming, yachting and showering; Timex lists light swimming. Timex saves snorkeling and poolside diving for 100 m.
- 10 ATM / 10 bar / 100 m (about 330 ft): Timex adds snorkeling, poolside diving and surfing; Seiko's chart adds bathing and shallow diving, and it treats 10, 15 and 20 bar alike.
- 20 ATM / 20 bar / 200 m (about 660 ft): Timex includes recreational scuba at 200 m; Seiko reserves scuba for watches built and marked as diver's watches.
- 30 bar / 300 m and higher: a big number alone doesn't make a dive watch. A watch that meets ISO 6425 is marked DIVER'S WATCH with its rated depth, so look for that marking if you plan to scuba dive.
Showers and baths are the gray area. Seiko's general chart allows showering from 5 bar and bathing from 10 bar, but its instruction manuals (the caliber 4R34 manual, for example) say not to wear the watch in a bath or sauna, because steam, soap and some hot-spring water can speed the loss of water resistance. The chart and the manual differ, and the manual's is the safer habit: take the watch off for hot showers and baths whatever the rating. These charts are the makers' guidance, not JewelryRepair.com's; your own watch's manual has the final word.
Habits that keep a watch water-resistant
- Leave the crown and buttons alone when wet. Seiko says not to turn or pull out the crown when the watch is wet, and Timex says not to press buttons underwater unless the watch is rated to 200 m.
- Check the crown before the water. It should be pushed fully in, or screwed down if yours screws. A missing crown, or one that pulls out or spins without setting the time, is a Stem & Crown Replacement (from $75). A screw-down crown that won't seal should start with the $19 Mail-In Evaluation, credited in full.
- Rinse after the sea. Seiko and Timex both say to rinse in fresh water after salt water, then dry the watch.
- Treat lasting fog as a warning. Seiko's advice is to get a watch seen promptly if condensation stays inside; see why a watch fogs up inside.
Ratings fade as gaskets age; for how that happens and how a case is resealed, see do watches lose water resistance over time.
How a pressure test works
A proper test puts the watch in a pressure chamber and checks it against the rating printed on it. In the Water-Resistance Pressure Test at JewelryRepair.com, the watchmaker checks the crown, case back and crystal seals under pressure and documents the result; if it fails, you get a note of where and a resealing quote to approve before any work. It's worth ordering before a beach trip, after a battery change done elsewhere, or on a pre-owned or vintage watch with no service history. It's a separate, documented test, not the routine check in the Watch Battery & Pressure Check.
What it costs at JewelryRepair.com
- Water-Resistance Pressure Test: $175 for most brands; some brands carry a surcharge of $15 to $200, shown in the configurator before checkout.
- Watch Battery & Pressure Check: $30 for most brands, or $55 with a new case back gasket ($30 + $25).
- Watch Crystal Replacement: from $75, with the case resealed; see crystal replacement.
- Stem & Crown Replacement: from $75.
- Watch Overhaul: $195 for quartz and $295 for mechanical ($195 + $100), finished with a reseal.
If your watch is still under its maker's warranty or a service plan, check with the maker first, because outside service can void it. JewelryRepair.com is an independent repair service, not affiliated with, authorized by or endorsed by any watch brand.
The watch travels by UPS for $30 round trip per order, with the prepaid label waiting in your account, $100 of coverage each way and a signature on delivery. At our New York studio it's photographed on arrival, a watchmaker at the bench does the work, a second jeweler checks it before it's photographed again and shipped back, and the work carries a 1-year workmanship guarantee. Sky Jewelry has been a family jeweler on Lenox Avenue since 1989, and its bench has handled over 50,000 repairs, watch batteries and reseals among them.
Questions
Can I shower with a 5 ATM watch?
Is 20 bar (200 m) enough for scuba diving?
Is 10 bar the same as 100 meters?
Does changing a watch battery affect water resistance?
Is a 10 ATM watch waterproof?
Related
JewelryRepair.com · Over 50,000 repairs since 1989
More repair questions · Repair glossary · How online jewelry repair works · Full price list