Repair questions · Earrings & pendants
How do you fix clip-on earrings that are too tight, too loose or broken?
From JewelryRepair.com: over 50,000 repairs since 1989 · 4.9 from 187 Google reviews (as of )
The short version
- Clip-ons work by pressure. The clip closes around the lobe and holds by mechanical pressure, which is also why they can ache after hours of wear.
- Too tight: add a soft silicone or foam pad, or ease the clip open a hair.
- Too loose: bow the clip slightly toward the earring, or add a pad for grip.
- Broken: a worn or missing hinge pin, or a paddle that wobbles on its hinge, is a hinge repair. A spring that's lost its snap, a snapped paddle or a clip broken off the earring needs a jeweler to look first. Heat ruins spring tension, so the clip has to come apart before anything is soldered.
- Vintage clips can be brittle: old metal hardens with age and old solder joints hide under patina, so have them evaluated before anyone bends them.
- Rather wear them pierced? Earring Back Conversion starts at $40.
Prices
| Service | Price | What's included |
|---|---|---|
| Hinge Repair | from $45 | For a clip hinge that's loose, wobbles or won't close: a worn or bent pin driven out and replaced with new wire, crushed or misaligned knuckles trued or rebuilt, a hinge tube torn away from the earring re-soldered, and the action set. Item type Earrings; gold and platinum add a metal charge. |
| Antique & Heirloom Restoration | $19 | For vintage and heirloom clips: the metal tested and every worn joint mapped under magnification, then each step quoted with photos before any work. The $19 is credited in full. |
| Earring Back Conversion | from $40 | If you'd rather wear them pierced: the clip removed cleanly at its mounting point and a post soldered on. Screwback or wire +$30, leverback +$40, omega +$60; gold adds a metal charge. |
| Mail-In Evaluation | $19 | For a spring that's lost its snap, a snapped paddle, a clip broken off the earring or a clip that needs replacing: examined under magnification, with photos and an itemized quote, credited in full toward approved work. |
Know your clip: the common mechanisms
- Hinged paddle (lever) clip. A flat or curved paddle on a sprung hinge flips down against the back of the lobe. In the usual two-part clip, the base is soldered to the earring and the springy paddle attaches to that base. The paddle's curve sets how close it closes, which makes this the most adjustable kind.
- Omega clip. A rounded, hinged loop shaped like the Greek letter omega snaps over and presses a pad against the lobe. Jewelers on the Ganoksin forum note that omega clips take a larger, donut-shaped pad.
- Screw clip (ear screw). A small threaded screw with a pad that you turn against the lobe. Wikipedia's earring article notes ear screws can be adjusted for fit and can also be part of a clip design.
Look at the back of your earring before you touch it: which of these you have decides what you can safely adjust and what needs a jeweler.
Why clip-ons hurt, and how to loosen one that's too tight
A clip-on holds by squeezing a small area of the lobe, so the force that keeps a heavy earring from sliding is the same force that pinches. Wikipedia's earring article notes that some people find clip-ons too painful after prolonged wear. Thin lobes, heavy earrings and a clip that closes too far all make it worse.
- Add cushioning first. Soft silicone or foam pads that slip over or stick onto the paddle spread the pressure and add grip, so you often don't need to change the tension at all. Jewelers on the Ganoksin forum suggest sleeve-style rubber or plastic pads and button-backed silicone pads that fit into the clip.
- Then open it slightly. With the clip open, hold the earring front in a soft cloth, and with your fingers or round-nose pliers wrapped in cloth or a rubber band, ease the paddle a hair away from the earring. Close it, try it, repeat. Small steps matter: the spring and hinge are tiny, and one hard bend can snap them.
- Give your ears a break. If a lobe stays red, numb or sore after you take them off, the clip is too tight for you even with pads.
How to tighten a clip that slips
- Reshape the paddle slightly toward the earring. Jewelers on the Ganoksin forum suggest round-nose pliers wrapped in cloth and moving the clip only a tiny amount at a time, testing after each small change.
- Add a pad. A silicone pad adds friction and thickness, so the clip grips without extra squeeze.
- Check the hinge. If the paddle wobbles side to side or closes off-center, the hinge pin or knuckles are worn, and bending won't fix that; it's a hinge repair.
- Adjust each clip on its own. Lobes differ, so if one earring slips and the other holds, change only the one that slips. A heavy or front-heavy earring pulls harder on any clip, so pads and small bends may not be enough for it.
When it's broken: what a jeweler does
Clip-ons fail in a handful of ways: the spring loses its snap, the hinge pin wears or falls out, the paddle snaps at the hinge, or the whole clip base breaks off the back of the earring. At the bench, the jeweler first works out which part failed. On a Hinge Repair, a worn or bent pin is driven out and replaced with new wire, crushed or misaligned knuckles (the small tubes the pin runs through) are trued or rebuilt, and a hinge torn away from the body is re-soldered.
Heat is the big risk. Jewelers on the Ganoksin forum warn that soldering a clip while it's assembled takes the springy tension out of the metal, so the spring part comes off first, the base is soldered and refinished, and the clip is reassembled afterward. They also note that a fresh clip can be fitted to an existing base when the original spring is worn out. At JewelryRepair.com, Hinge Repair covers the hinge itself. A dead spring, a snapped paddle, a clip broken off the earring or a replacement clip doesn't map to one listed repair, so it starts with the $19 Mail-In Evaluation, credited in full, or a free photo quote, and you see the price before any work. Glue isn't a fix: the clip is under spring tension every time it opens, and a glued joint lets go.
Vintage and costume clips need extra care. Antique metal grows brittle with age, old solder joints hide under patina, and many costume pieces combine plated base metal with stones that may not tolerate heat. For those, Antique & Heirloom Restoration starts with the $19 evaluation: the metal is tested, every worn joint is mapped, and each step is quoted before any work. See also vintage earring backs and whether costume jewelry can be repaired.
Can I fix a broken clip-on myself?
Adjusting the tension and adding pads, yes, carefully. Replacing a hinge pin, re-soldering a clip base or fitting a new clip, realistically no: the parts are tiny, a torch near the spring destroys its tension, and soldering next to plating or set stones can damage both. Superglue on a snapped clip won't hold for long, because the joint flexes every time you open it. On an inexpensive fashion pair, replacement clip findings from a craft supplier may cost less than any repair. On gold, silver or a family piece, let a jeweler do it.
What it costs at JewelryRepair.com
Prices from the live repair pages, Nov 18, 2026.
- Clip hinge or pin: Hinge Repair with item type Earrings is $45 in sterling silver, $62 in 14K gold ($45 + $11 + $6), $76 in 18K gold ($45 + $11 + $20) and $140 in platinum ($45 + $95).
- Dead spring, snapped paddle, clip broken off or a replacement clip: the $19 Mail-In Evaluation, credited in full, or a free photo quote through the contact page.
- Vintage or heirloom clips: Antique & Heirloom Restoration from $19, the evaluation price, credited in full.
- Not sure what's wrong: the same $19 evaluation, which names the failed part before any price is set.
- Switch to pierced: Earring Back Conversion is $40 in sterling silver with stick posts, $70 with screwbacks ($40 + $30), and $106 in 14K yellow gold with stick posts ($40 + $55 + $11). See converting clip-ons to pierced.
Send both earrings even if only one clip has failed, so the jeweler can match the repaired clip's tension to the good one, and note in your order which ear slips or pinches. Every price includes a clean and polish and the 1-year workmanship guarantee, and the pair travels for one $30 round trip by UPS, with $100 of coverage each way. JewelryRepair.com is the mail-in service of Sky Jewelry, family jewelers on Lenox Avenue since 1989, with over 50,000 repairs since 1989; your earrings are photographed on arrival and before they ship back, and a second jeweler checks the clips after the bench jeweler's work.
Questions
Are clip-on earrings supposed to hurt?
How do I keep clip-on earrings from falling off?
Can a jeweler fix vintage clip-on earrings?
Can you glue a broken clip-on earring?
How do you loosen clip-on earrings that pinch?
Related
JewelryRepair.com · Over 50,000 repairs since 1989
More repair questions · Repair glossary · How online jewelry repair works · Full price list