Jewelry repair questions · Watches

Why did my watch stop working, even after a new battery?

Usually it's a dead battery in a quartz watch, or an automatic that hasn't been worn enough to stay wound. If a fresh battery doesn't fix it, suspect a crown left pulled out, moisture, a cell that leaked, magnetism, or a dirty movement that needs service. At JewelryRepair.com a stopped watch gets a free diagnosis first; batteries start at $30.

From JewelryRepair.com: over 50,000 repairs since 1989 · 4.9 from 187 Google reviews (as of )

$30Watch Battery & Pressure Check, most brands
$195 / $295Watch Overhaul for quartz / mechanical, most brands
about 2 daystypical run time of a fully wound automatic
50,000+repairs since 1989

The short version

  • Quartz watch: start with the battery. Silver-oxide watch cells hold a steady voltage and then drop suddenly at the end of their life, so a watch can run perfectly one day and stop the next.
  • Automatic watch: it may simply have run down. A full wind typically stores enough energy for roughly two days.
  • New battery, still stopped? Check that the crown is pushed fully home. After that, the likely causes are a dirty or dry movement, moisture, corrosion from an old cell that leaked, or a part damaged by a knock.
  • Stops and starts? A watch that stops intermittently or runs fast or slow needs an overhaul, not another battery.

Prices

Service PriceWhat's included
Watch Battery & Pressure Check from $30The case opened with the right tool, a fresh cell of the size the movement specifies, contacts and movement inspected, the gasket checked and the case pressure-checked. Two-cell watches add $30, a solar cell $85.
Watch Overhaul from $195 quartz
from $295 mechanical
Full movement service: disassembly, ultrasonic cleaning, inspection for wear, fresh oils, regulation and reseal. The repair for a watch that stops on and off, runs fast or slow, or dies again after a new battery. Can't be rushed.
Stem & Crown Replacement from $75For a crown that pulls out, spins without setting the time, or is missing: a new stem cut to length and a crown matched to the case, with a fresh gasket where the design calls for one; winding, setting and date tested.
Mail-In Evaluation $19For a watch with several problems, or anything else you'd like examined: photos and an itemized quote, credited in full. A watch that simply stops gets a free diagnosis through Start a Repair instead.

Quartz watches: when it's the battery

A quartz movement runs on a small cell that powers its circuit and a stepping motor, so when the cell is spent, everything stops, often sooner than people expect:

  • A battery has a working life. Seiko's instructions for one of its quartz calibers give about 3 years on a new battery, and less with heavy use of the watch's functions.
  • The first battery is often short-lived. Makers fit a monitor battery at the factory to test the watch, and both Seiko and Citizen note it may run out sooner than the manual says.
  • Many watches warn you first. On some, the second hand starts jumping in 2- or 4-second steps when the cell is low; Omega says its watches keep running for a few days after that warning.
  • Solar watches are different. A solar watch that stops usually needs light, not a battery. Citizen's advice is to put the dial in direct sunlight for several hours. See do solar watches need a new battery?

Don't leave a dead cell in a stopped watch; see can a dead battery left in a watch damage it?

When a new battery doesn't fix it

A faulty new cell is rare. If a fresh battery didn't bring the watch back, or it ran a few weeks and stopped again, look elsewhere:

  • The crown is out. On watches that hack, pulling the crown out to set the time stops the movement on purpose, so a crown left out leaves the watch looking dead. Push it fully home, and screw it down if it's a screw-down crown. A crown that won't stay in, or spins without setting, is Stem & Crown Replacement, from $75.
  • The movement is dirty or dry. Quartz watches still turn their hands through gears that run in oil. Citizen notes that oil which has broken down or dried up, mixed with worn metal particles, raises power consumption and shortens battery life. The fix is a service, not another battery. See why a watch battery dies so fast.
  • The old cell leaked. Green or white crust in the battery well means corrosion has reached the contacts or beyond. Damaged parts are photographed and quoted before anything is replaced.
  • Moisture got in. Citizen says fog that clears within a couple of minutes of drying the glass is no problem, but fog that lasts points to a compromised seal. See why is my watch fogged up inside?
  • Something broke. Longines notes that shocks can block gears or damage components; that's what the diagnosis is for.

Automatic and hand-wound watches

  • It ran down. A fully wound mainspring typically stores enough energy for roughly two days, so an automatic left off for a day or two stops; that's normal. A hand-wound watch stops whenever it isn't wound.
  • It isn't getting enough motion. Longines notes that a sedentary routine may not generate enough motion to keep an automatic wound. To restart one, wind it with the crown pushed in: 20 to 30 turns, the figure Longines gives for winding a stuttering automatic by hand. See how to wind an automatic or manual watch and why an automatic stops overnight.
  • It's magnetized. Magnetism makes the coils of the hairspring stick together, so the watch suddenly runs very fast or slow, and a strong field can stop it. Phones, speakers and some handbags carry magnets. See is my watch magnetized?
  • It needs service. Movement oil doesn't last forever: Longines suggests a service every 3 to 5 years, Omega a complete service every 5 to 8. A watch that stops even when fully wound needs a watchmaker; if it won't wind at all, see why won't my watch wind?

Checks to try before you send it

  • Push the crown fully home, and screw it down if it's that type.
  • Automatic: wind it, set it, and watch it for a day. Solar: leave the dial in direct sunlight for several hours.
  • Look for fog or droplets under the crystal. If you see them, keep the watch dry, don't pull the crown, and send it in rather than waiting.
  • Note what happened: stopped overnight, on the wrist, after a knock, a swim or a new battery. It shortens the diagnosis.
  • Don't open the case back to look: a slipping tool scratches it, and a disturbed gasket lets moisture in.

What it costs at JewelryRepair.com

Prices from the live repair pages, Nov 18, 2026. Book through Start a Repair and choose a watch that stops: it gets a free diagnosis first, and nothing is done until you approve the work and its price. If you decline, it ships back with nothing more to pay, because the $30 round-trip shipping already covers the return.

  • Battery: Watch Battery & Pressure Check, $30 for most brands, gasket inspected and case pressure-checked. Two cells add $30, a solar cell $85.
  • Service: Watch Overhaul, $195 for quartz and $295 for mechanical ($195 + $100) with most brands. Overhauls can't be rushed.
  • Crown or stem: Stem & Crown Replacement, from $75.
  • Water or fog inside: also diagnosed free first; that work starts from $175.
  • Several problems at once: the Mail-In Evaluation, $19, credited in full.

Some brands carry their own charge; see watch repair by brand. If the watch is still under its maker's warranty or a service plan, check with the maker first, because outside service can void it. JewelryRepair.com is an independent repair service, not affiliated with, authorized by or endorsed by any watch brand named on this page.

Before you ship

  • Ship in a plain padded box with the prepaid UPS label from your account. $100 of coverage is included each way; full value up to $10,000 costs 2.5% of the value above $100 ($72.50 for a $3,000 watch: $2,900 × 2.5%).

Your watch is photographed when it reaches the New York studio and again before it ships back; a bench jeweler does the work, a second jeweler checks it, and it carries a 1-year workmanship guarantee. JewelryRepair.com is the mail-in repair service of Sky Jewelry, family jewelers on Lenox Avenue since 1989, with over 50,000 repairs since 1989.

Questions

Why does my watch stop when I'm wearing it?
Usually because the movement needs service or, on a mechanical watch, it's magnetized. A watch that stops on and off while worn is the classic sign a movement needs an overhaul, and magnetism makes a mechanical watch run very fast or slow and can stop it altogether. Some solar watches also stop their hands to save power under a sleeve. At JewelryRepair.com a stopped watch gets a free diagnosis first.
Why did my watch stop after a new battery?
Most often the battery was never the problem. A crown left pulled out, a dirty or dry movement, corrosion from the old cell, moisture, or a part damaged by a knock can all look like a dead battery. Check that the crown is pushed fully home; if it still won't run, it needs a diagnosis. A quartz overhaul at JewelryRepair.com is $195 for most brands.
Why did my watch stop after I took it off?
If it's an automatic, it has most likely run down: with no wrist motion it lives on its power reserve, typically about two days from a full wind, and less if it was never fully wound. Some solar watches also stop their hands to save power in a drawer. Wind or light it and set it; if it stops again while fully wound, it needs a diagnosis.
Should I change my watch battery myself?
Only if you're sure of the cell and the case. Citizen notes that dust can get in when the back is opened, which may stop the watch or weaken its water resistance, and Seiko recommends a water resistance test at each battery change for watches rated 10 bar or more. At JewelryRepair.com, Watch Battery & Pressure Check is $30 for most brands, with the gasket inspected and the case pressure-checked.