Jewelry repair questions · Watches

How do you wind an automatic or manual watch, and how often?

Take the watch off, unscrew a screw-down crown and turn it clockwise. Wind a hand-wound watch once a day until the crown meets firm resistance, never past it. An automatic winds as you wear it; to restart one, turn the crown or swing it until the seconds hand moves. A mechanical overhaul at JewelryRepair.com is $295 for most brands.

From JewelryRepair.com: over 50,000 repairs since 1989 · 4.9 from 187 Google reviews (as of )

About 2 daystypical run time of a fully wound automatic
~20 / ~60crown turns for a daily wind / after 3+ days stopped, on Grand Seiko's hand-wound 72-hour Cal. 9S64
$295Watch Overhaul, mechanical, most brands ($195 + $100)
50,000+repairs since 1989 by Sky Jewelry's family of jewelers

The short version

  • Hand-wound: once a day, at about the same time, until the crown meets firm resistance. Stop there.
  • Automatic: wearing it winds it. To restart a stopped one, turn the crown or swing it gently until the seconds hand moves, then set the time.
  • You can't overwind an automatic: its mainspring slips inside the barrel once it's full.
  • If it won't hold a wind, the watch needs service, not more winding.

Prices

Service PriceWhat's included
Watch Overhaul from $295 mechanical
from $195 quartz
For a watch that won't hold a wind, stops while worn, runs fast or slow, or hasn't been serviced in five or more years: movement taken apart, cleaned, lubricated, regulated and resealed. Most brands; any brand surcharge shows before checkout.
Stem & Crown Replacement from $75A crown that pulls out, spins without winding or setting, or is missing: a new stem cut to the length your case needs, a crown matched in size and thread with a fresh gasket where the design calls for one, then winding, setting and date tested. Most brands.
Water-Resistance Pressure Test from $175If a screw-down crown was left open near water: a documented pressure-chamber test against the watch's depth rating, with resealing quoted if it fails.
Mail-In Evaluation $19For a crown that turns with no resistance, a gritty feel, or a fault you can't pin down: examined under magnification, with an itemized quote and photos, credited in full toward the repair.

Automatic or hand-wound: which do you have?

Both are mechanical watches powered by a coiled mainspring. A hand-wound (manual) watch is wound only through the crown. An automatic adds a weighted rotor that swings as your wrist moves and winds the spring for you. Many dials or case backs say Automatic or Self-winding; through a display back you'll see the half-moon rotor. A watch with neither marking and no rotor is usually hand-wound.

Two cases trip people up. Some automatics can't be wound by hand at all: Seiko's watches built on the 7S26 movement are the well-known example, so a crown that doesn't wind isn't proof of a fault. And a quartz watch's crown doesn't wind anything, because a battery runs it. If you're not sure which you have, see quartz vs automatic: how to tell.

How to wind a hand-wound watch

With the crown in its winding position (pushed fully in, or unscrewed and sprung out on a screw-down crown), turn it clockwise between thumb and forefinger in short, even strokes. You'll feel and sometimes hear a light ratcheting click; that's normal. As the spring tightens, the crown gets steadily harder to turn. When it stops at firm resistance, the watch is fully wound.

That point matters. Breguet's manual for one hand-wound model says to wind until resistance is felt, notes that a safety system prevents breakage if the watch is over-wound, and still recommends not forcing the crown beyond the point of resistance. Wikipedia's mainspring article explains where the overwinding myth comes from: older springs broke from metal fatigue, often at the end of winding when the spring was tightest, so the winding got the blame. Modern watches are designed to be wound all the way; forcing past full is a different matter.

Wind once a day, ideally at the same time. How many turns that takes depends on the movement. Grand Seiko's manual for its hand-wound 72-hour Cal. 9S64 says about 20 turns fully winds it day to day, and about 60 if it has sat for more than three days. If you skip a day and the watch stops, wind it fully and set the time.

How to wind an automatic watch

Wearing it is the winding. Seiko's instructions for its 4R automatic calibers say to wear the watch for more than 10 hours a day, or, if it isn't worn, to wind it fully every day at a fixed time, because a partly wound watch can gain or lose time. Fully wound, those calibers run about 41 hours, and Wikipedia gives roughly two days as typical for an automatic.

To start one that has stopped:

  • Turn the crown clockwise, or swing the watch gently side to side, until the seconds hand moves. Seiko notes that crown winding alone may not start a stopped watch right away, because the spring's force is low at first.
  • Then set the time (and the date; see when not to change the date).

Extra turns won't hurt it. An automatic's mainspring ends in a slipping bridle that lets it slide around the barrel once full, a device patented by Adrien Philippe in 1863. Seiko says turning further will not break the spring. A watch winder isn't required either. A New York watchmaker told Gear Patrol that unworn watches don't need to keep moving to protect their lubricants, and that a winder keeps the gears and pivots of a watch overdue for service wearing.

Mistakes that damage crowns and stems

  • Winding on the wrist. The sideways push on the crown is exactly the lateral pressure on the stem that Patek Philippe's manual warns about.
  • Leaving a screw-down crown open. Seiko's instructions say to lock the crown after operating it. An open crown is a gap in the case's seal, and fog under the crystal after a shower or swim is the warning sign.
  • Cross-threading it. Press the crown in gently while you screw it down, and stop when it's snug. If it won't catch or feels gritty, don't force it; see why a watch crown gets stuck or stiff.
  • Winding in the wrong position. Pulled out to the setting position, the crown moves the hands instead of winding.
  • Forcing a hand-wound crown past firm resistance, or using pliers on a crown that's hard to grip.

When winding doesn't fix it

Winding fixes a watch that simply ran down. These signs point to the watch itself:

  • It stops within hours of a full wind, far short of its rated reserve. Mainsprings tire and lose force over the years, and a dirty or dry movement can stop with the spring still fully wound, which owners often mistake for overwinding. Both are handled in a Watch Overhaul.
  • The crown turns with no resistance at all and the watch won't start. That can be a broken mainspring or a winding part; see why a watch won't wind, and start with the $19 Mail-In Evaluation rather than guessing.
  • The crown pulls out, spins without setting the time, or is gone. That's Stem & Crown Replacement, from $75. An open stem hole lets dust and moisture into the movement, so don't wear it that way.
  • It runs fast or slow, stops on and off, or hasn't been serviced in five or more years. The oils that keep the movement running don't last forever; that's an overhaul.
  • Fog or moisture under the crystal. The Start a Repair wizard sends it to a free diagnosis first; a Water-Resistance Pressure Test starts at $175.

What it costs at JewelryRepair.com

Prices from the live repair pages, Nov 18, 2026. Each includes the 1-year workmanship guarantee, and the configurator shows the exact total before checkout.

  • Watch Overhaul: $295 for a mechanical watch of most brands ($195 + $100 for a mechanical movement); $195 for quartz. Brand surcharges show before checkout: a mechanical Omega is $310 and a mechanical Rolex $495. Overhauls can't be rushed and take longer than the roughly three weeks most repairs take.
  • Stem & Crown Replacement: from $75 for most brands; TAG Heuer adds $120 and Rolex $200.
  • Mail-In Evaluation: $19, credited in full toward the work you approve.

Under the maker's warranty or a service plan? Check with the maker first, because outside service can void it. JewelryRepair.com is an independent repair service, not affiliated with or endorsed by any watch brand. A $3,000 automatic can be insured for its full value for $72.50 (2.5% of $2,900), both directions, on top of the $30 UPS round trip; the watch is photographed on arrival at the New York studio and before it ships back, and a second jeweler checks the work. Sky Jewelry, family jewelers on Lenox Avenue since 1989, runs JewelryRepair.com: over 50,000 repairs since 1989.

Questions

How many times should you wind an automatic watch?
There's no fixed count: turn the crown until the seconds hand is running, then let wearing do the rest. Seiko's instructions for its 4R automatics say to wear the watch more than 10 hours a day, or wind it fully daily if it isn't worn, and that turning further won't break the spring, because an automatic's mainspring slips once full. Turn counts you see quoted, such as Grand Seiko's 20 a day, are for hand-wound calibers.
Is it bad to wind a watch backwards?
No, but it does nothing on most watches: the backward turn doesn't engage the winding, and Seiko's instructions say its automatics can't be wound counterclockwise. Wind clockwise, toward 12 o'clock. What actually damages crowns and stems is winding on the wrist at an angle, winding a screw-down crown before it's fully unscrewed, and forcing a hand-wound crown past firm resistance.
Should I wind my automatic watch every day?
Only if you don't wear it. Seiko advises wearing an automatic more than 10 hours a day, or, if it isn't worn, winding it fully every day at a fixed time, because a partly wound watch can gain or lose time. If you wear it daily, a top-up after a short day is plenty, and letting it stop on the nightstand doesn't harm it.
Is it bad to leave a mechanical watch unwound?
No. A stopped watch simply waits to be wound. A New York watchmaker told Gear Patrol that unworn watches don't need to keep moving to protect their lubricants. The oils still age with time, which is why service is measured in years: a Watch Overhaul is $295 for a mechanical watch of most brands.
Can you overwind a manual watch?
Not in normal winding, but you can force one. A hand-wound watch is full when the crown meets firm resistance; Breguet's manual notes a safety system against breakage and still recommends not forcing the crown past that point. If the crown suddenly turns with no resistance at all, something inside may have broken. Start with the $19 Mail-In Evaluation, credited in full toward the repair.